Video Instruction

Making Buttons:

How to make a 25mm pin badge button with your Button Maker B400

How to make 25mm Double-side keychain/Versa-back Keychain/Rubber Magnet Buttons

How to make a 32mm Pin Badge & Rubber Magnet Button

How to make a 37mm Pin Badge & Rubber Magnet Button

ChiButtons on making 44mm Pin badge, Rubber Magnet, Mirror Button, and Bottle Opener Keychain

How to use your 58mm Button Maker Kit to Make a Pin-back Button

How to make a 75mm Pin Badge & Rubber Magnet & Mirror Button

How to make a 100mm pin badge button

ChiButtons on making 44mm cellphone stand button

How to make a 37*37mm Square Pin Badge and Rubber Magnet Button

How to make a 53*57.5mm heart Pin badge and Rubber Magnet Button

How to make a 25*70mm Rectangle Pin Badge and a Rubber Magnet Button

How to make a 40*60mm Rectangle Pin Badge and a Rubber Magnet Button

How to make a 50*90mm Rectangle Pin Badge and a Rubber Magnet Button

How to make a 58*60 Pentagon Pin Badge and Rubber Magnet Button

How to make a 58*65 Hexagon Pin Badge and Rubber Magnet Button

How to make a 63*70mm triangle Pin Badge

How to make a 45*65mm oval Pin Badge, Magnet Bottle Opener, and Rubber Magnet Button

How to make a 60*90mm oval Pin Badge, Magnet Bottle Opener, and Rubber Magnet Button

Assembly and Button Making Guide for Maker-1

Using Cutters:

Button Maker S1/B400-Button Making Machine Assembly Instructions

1. Install the acrylic board: screw in the machine body on the acrylic board with the washers.
2. Putting on the handle: simply screw the handle to the upper lot.
3. Installation of Moulds:

              (1) Installing the upper mould: insert the upper mould with the 1 cm metal stick facing you, feel free to slightly spin around the mould till its top magnet bar is secured.
              (2) Slot in the A mould and B mould on the swivel/rotary plate with the letter A & B respectively facing the corresponding letter on the plate.

Making a Pin Button/ a Magnet Button/ a Bottle Opener with Magnet using B400

1. Place an upper shell onto A mould with the sharp edge facing downward. Place the graphic/design paper on the shell followed by a piece of Mylar. Align the graphic to the vertical pin of the A mould to adjust orientation.
2. Rotate/swivel the plate to set A mould properly stop by the upper mould. Hold the machine body by one hand and pull down the handle gently till its furthest then release it.
3. Place a back component onto B mould with the sharp edge facing up. Align the back to the vertical pin of the B mould for proper orientation. When making the metal back pin button, the magnet button, (32/37/44/58/65/75mm), the bottle opener(58/65mm), a washer/gasket is recommended to put onto B mould before the back component goes in.
4. Repeat step#2 but set B mould instead.
5. Rotate/swivel the plate to collect the finished button.

Warning:

1. When changing the upper mould, be careful of the top mould dropping.
2. Please do not put your fingers between the upper mould and the bottom moulds.

Button Maker B400 Assembly Guide: