My Cart:

0 item(s) - $0.00
You have no items in your shopping cart.

0

How-to Instructions

Video Instructions

 

 

SDHP S1-Button Making Machine Assembly Instructions

  1. Install the acrylic board:using the washer,screw to fix the machine body on the acrylic board.
  2. Fix the handle:fix the handle on the machine body.
  3. Install the mould
    1. Install the upper mould:insert the upper mould into the upper hole,then the upper mould will be adsorbed in the machine.
    2. Place the mould A into symbol “A” slot and mould B into symbol “B” slot.
    3. Location pins for mould A&B should be located inside of the machine body.

 

Assembly is completed -

Note: When using the large 100/100mm mould, the location pin is placed outside of the machine main body.

 

 

SDHP-1 Button Making Machine Assembly Instructions

  1. Install the acrylic board:using the screw to fix the machine body on the acrylic board.
  2. Fix the handle: fix the handle on the machine body.
  3. Install the mould.
    1. Pull the handle down, and insert the upper mould into the upper hold.The upper mould.
    2. Up the upper mould, then insert the bottom moulds through the slide trough.
    3. Insert the location pin in to the left hole of the slide board.

 

 

SDHP-N1 Button Making Machine Assembly Instructions

Refer to Step 1&2 of SDHP-1 installation to install the acrylic board and the handle.

  1. Install the upper mould: insert the upper mould in to the upper hold, then the upper mould will be adsorbed in the machine.
  2. Install A mould:fix A mould on the left slot of the slide.
  3. Install B mould:fix the B mould on the right slot of the slide.
  4. Complete the installation.Fasten the location pins in both side of slide.

Don’t use too much pressure when changing the upper mould,mind your fingers.

 

 

Making a Pin Button/ a Magnet Button/ a Bottle Opener with Magnet using SDHP-N3 /B400

  1. Place a shell into A mould with the sharp edge facing downward.Place the graphic on the shell.Place the mylar on top of the graphic.Line up the top of the graphic to the location pin for correct orientation.
  2. Rotate the mould table until the upper mould is facing to A mould.Hold the button making machine by one hand, and pull the handle down as far as it will go and raise it back up to its rest position.
  3. Place a pinned back or a magnet back or a bottle opener back in to B mould with the sharp edge facing up.Line up the top of the back slightly to the location pin for correct orientation.When making the metal back pin button, the magnet button,(32/37/44/58/65/75mm), the bottle opener(58/65mm), a gasket needs to be put in B mould.
  4. Rotate the mould table until the upper mould is facing to B mould.Pull the handle down as far as it will go and raise it back up to its rest position.
  5. Rotate the mould table again to remove the finished button.
    1. Draw down the upper mould when chaging it.Mind your fingers in care of mould dropping-off.
    2. Do not put your finders between the upper mould and the bottom moulds,in case hurting your fingers.